TLV1571, TLV1578

2.7 V TO 5.5 V, 1-/8-CHANNEL, 10-BIT,

PARALLEL ANALOG-TO-DIGITAL CONVERTERS

SLAS170C –MARCH 1999 – REVISED FEBRUARY 2000

8

POST OFFICE BOX 655303

detailed description (continued)

reference voltage input

The TLV1571/TLV1578 has two reference input pins: REFP and REFM. The voltage levels applied to these pins

establish the upper and lower limits of the analog inputs to produce a full-scale and zero-scale reading

respectively. The values of REFP, REFM, and the analog input should not exceed the positive supply or be less

than GND consistent with the specified absolute maximum ratings. The digital output is at full scale when the

input signal is equal to or higher than REFP and is at zero when the input signal is equal to or lower than REFM.

sampling/conversion

All sampling, conversion, and data output in the device are started by a trigger. This could be the RD, WR, or

CSTART signal depending on the mode of conversion and configuration. The rising edge of RD, WR, and

CSTART signal are extremely important, since they are used to start the conversion. These edges need to stay

close to the rising edge of the external clock (if they are used as CLK). The minimum setup and hold time with

respect to the rising edge of the external clock should be 5 ns minimum. When the internal clock is used, this

is not an issue since these two edges will start the internal clock automatically. Therefore, the setup time is

always met. Software controlled sampling lasts 6 clock cycles. This is done via the CLK input or the internal

oscillator if enabled. The input clock frequency can be 1 MHz to 20 MHz, translating into a sampling time from

0.6

µs to 0.3 µs. The internal oscillator frequency is 9 MHz minimum (oscillator frequency is between 9 MHz

to 22 MHz), translating into a sampling time from 0.6

µs to 0.3 µs. Conversion begins immediately after sampling

and lasts 10 clock cycles. This is again done using the external clock input (1 MHz–20 MHz) or the internal

oscillator (9 MHz minimum) if enabled. Hardware controlled sampling, via CSTART, begins on falling CSTART

lasts the length of the active CSTART signal. This allows more control over the sampling time, which is useful

when sampling sources with large output impedances. On rising CSTART, conversion begins. Conversion in

hardware controlled mode also lasts 10 clock cycles. This is done using the external clock input (1 MHz–20 MHz)

or the internal oscillator (9 MHz minimum) as is the case in software controlled mode.

NOTE: tsu = setup time, th = hold time

ExtClk

WR

RD

CSTART

tsu(WRH_EXTCLKH) ≥5 ns

th(WRL_EXTCLKH) ≥5 ns

th(RDL_EXTCLKH) ≥5 ns

td(EXTCLK_CSTARTL) ≥5 ns

th(CSTARTL_EXTCLKH) ≥5 ns

tsu(CSTARTH_EXTCLKH)

≥5 ns

OR

OR

tsu(RDH_EXTCLKH) ≥5 ns

Figure 3. Trigger Timing – Software Start Mode Using External Clock