LC87F1JJ2A

No.A1453-5/28

Standby Function

• HALT mode: Halts instruction execution while allowing the peripheral circuits to continue operation.

1) Oscillation is not halted automatically.

2) There are three ways of releasing the HALT mode.

(1) Setting the reset pin to the lower level.

(2) System resetting by watchdog timer

(3) Generating an interrupt

• HOLD mode: Suspends instruction execution and the operation of the peripheral circuits.

1) The PLL base clock generator, CF, RC and crystal oscillators automatically stop operation.

2) There are five ways of releasing the HOLD mode.

(1) Setting the reset pin to the lower level

(2) System resetting by watchdog timer

(3) Having an interrupt source established at one of the INT0, INT1, INT2, INT4, and INT5 pins

* The INT0 and INT1 pins must be configured only for level detection.

(4) Having an interrupt source established at port 0

(5) Having an bus active interrupt source established in the USB host control circuit

• X'tal HOLD mode: Suspends instruction execution and the operation of the peripheral circuits except the base timer.

1) The PLL base clock generator, CF and RC oscillator automatically stop operation.

2) The state of crystal oscillation established when the X'tal HOLD mode is entered is retained.

3) There are seven ways of releasing the X'tal HOLD mode.

(1) Setting the reset pin to the low level

(2) System resetting by watchdog timer

(3) Having an interrupt source established at one of the INT0, INT1, INT2, INT4, and INT5 pins

* The INT0 and INT1 pins must be configured only for level detection.

(4) Having an interrupt source established at port 0

(5) Having an interrupt source established in the base timer circuit

(6) Having an bus active interrupt source established in the USB host control circuit

(7) Having an interrupt source established in the infrared remote controller receiver circuit

Package Form

• SQFP48(7×7): Lead-/Halogen-free type

Development Tools

• On-chip debugger: TCB87- type B + LC87F1JJ2A

Flash ROM Programming Boards

Package

Programming board

SQFP48(7

×7)

W87F55256SQ

Flash ROM Programmer

Maker

Model

Supported Version

Device

Flash Support Group, Inc.

(FSG)

Single

AF9708/

AF9709/AF9709B/AF9709C

(including Ando Electric Co., Ltd. models)

Rev. 03.12 or later

LC87F1JJ2A

AF9101/AF9103(main unit)

(FSG)

Flash Support Group, Inc.

(FSG)

+

SANYO(Note 1)

Onboard

single/ganged

SIB87(interface driver)

(SANYO)

(Note 2)

LC87F1JJ2A

Single/ganged

SKK/SKK Type B

(SANYO FWS)

SANYO

Onboard

single/ganged

SKK-DBG Type B

(SANYO FWS)

Application version:

1.04 or later

Chip data version:

2.17 or later

LC87F1JJ2

Note 1: PC-less standalone onboard programming is possible using the FSG onboard programmer (AF9101/AF9103)

and the serial interface driver (SIB87) provided by SANYO in pair.

Note 2: Dedicated programming device and program are required depending on the programming conditions. Contact

SANYO or FSG if you have any questions or difficulties regarding this matter.