Specifications of any and all SANYO products described or contained herein stipulate the performance,

characteristics, and functions of the described products in the independent state, and are not guarantees

of the performance, characteristics, and functions of the described products as mounted in the customer's

products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,

the customer should always evaluate and test devices mounted in the customer's products or equipment.

SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all

semiconductor products fail with some probability. It is possible that these probabilistic failures could

give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire,

or that could cause damage to other property. When designing equipment, adopt safety measures so

that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective

circuits and error prevention circuits for safe design, redundant design, and structural design.

In the event that any or all SANYO products(including technical data,services) described or

contained herein are controlled under any of applicable local export control laws and regulations,

such products must not be expor ted without obtaining the expor t license from the author ities

concerned in accordance with the above law.

No part of this publication may be reproduced or transmitted in any form or by any means, electronic or

mechanical, including photocopying and recording, or any information storage or retrieval system,

or otherwise, without the prior written permission of SANYO Electric Co., Ltd.

Any and all information described or contained herein are subject to change without notice due to

product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification"

for the SANYO product that you intend to use.

Information (including circuit diagrams and circuit parameters) herein is for example only ; it is not

guaranteed for volume production. SANYO believes information herein is accurate and reliable, but

no guarantees are made or implied regarding its use or any infringements of intellectual property rights

or other rights of third parties.

This catalog provides information as of January, 2001. Specifications and information herein are subject

to change without notice.

TND025F, 025MP

PS No.6036–4/4

Operation Description

1.The output power MOSFET will be turned on when the input voltage exceeds the input threshold voltage (5V is

recommended), and then the lamp will be turned on by the current flowing to the lamp.Conversely, the output

power MOSFET will be turned off when the input voltage goes below the input threshold voltage, and then the

lamp will be turned off.

2.The internal overcurrent protection function shuts down the output power MOSFET when output current of at

least the overcurrent detecting current value flows at load short. Besides, if the device temperature exceeds the

allowable power dissipation, overheat protection function protects the power switch from being broken down by

shutting down the MOSFET when Tj comes to 165˚C (typical).

3.Shutdown state will be kept after overheat and overcurrent protections operation and the system will be reset

when the input voltage goes to or below the reset voltage (1.0V).

4.As an example of application circuit, DC voltage can also be controlled as a solenoid drive.

Sample Application Circuit

Another Sample Application Circuit

(solenoid drive)

OUT

GND

TND025F/TND025MP

IN

5V

AC100V

AC24V

OUT

GND

IN

5V

AC100V

AC24V

TND025F/TND025MP

Micro-

controller

Lamp

Micro-

controller

Solenoid