Electronic Components Datasheet Search
  English  ▼
ALLDATASHEET.NET

X  

ADP222ACPZ-1825-R7 Datasheet(PDF) 4 Page - Analog Devices

Part # ADP222ACPZ-1825-R7
Description  Dual, 300 mA Output, Low Noise
Download  24 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
Manufacturer  AD [Analog Devices]
Direct Link  http://www.analog.com
Logo AD - Analog Devices

ADP222ACPZ-1825-R7 Datasheet(HTML) 4 Page - Analog Devices

  ADP222ACPZ-1825-R7 Datasheet HTML 1Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 2Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 3Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 4Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 5Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 6Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 7Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 8Page - Analog Devices ADP222ACPZ-1825-R7 Datasheet HTML 9Page - Analog Devices Next Button
Zoom Inzoom in Zoom Outzoom out
 4 / 24 page
background image
ADP222/ADP223/ADP224/ADP225
Data Sheet
Rev. B | Page 4 of 24
Parameter
Symbol
Test Conditions/Comments
Min
Typ
Max
Unit
OUTPUT NOISE
OUTNOISE
10 Hz to 100 kHz, VIN = 5 V, VOUT = 3.3 V
56
µV rms
10 Hz to 100 kHz, VIN = 5 V, VOUT = 2.8 V
50
µV rms
10 Hz to 100 kHz, VIN = 3.6 V, VOUT = 2.5 V
45
µV rms
10 Hz to 100 kHz, VIN = 3.6 V, VOUT = 1.2 V
27
µV rms
POWER SUPPLY REJECTION RATIO
PSRR
VIN = 2.5 V, VOUT = 0.8 V, IOUT = 100 mA
100 Hz
76
dB
1 kHz
76
dB
10 kHz
70
dB
100 kHz
60
dB
1 MHz
40
dB
VIN = 3.8 V, VOUT = 2.8 V, IOUT = 100 mA
100 Hz
68
dB
1 kHz
68
dB
10 kHz
68
dB
100 kHz
60
dB
1 MHz
40
dB
1
Accuracy when VOUTx is connected directly to ADJx or SENSEx. When the VOUTx voltage is set by external feedback resistors, the absolute accuracy in adjust mode
depends on the tolerances of resistors used.
2
Based on an end-point calculation using 1 mA and 300 mA loads.
3
Dropout voltage is defined as the input-to-output voltage differential when the input voltage is set to the nominal output voltage. This applies only for output
voltages above 2.5 V.
4
Start-up time is defined as the time between the rising edge of EN to VOUT being at 90% of its nominal value.
5
Current-limit threshold is defined as the current at which the output voltage drops to 90% of the specified typical value. For example, the current limit for a 3.0 V
output voltage is defined as the current that causes the output voltage to drop to 90% of 3.0 V or 2.7 V.
INPUT AND OUTPUT CAPACITOR, RECOMMENDED SPECIFICATIONS
The minimum input and output capacitance should be greater than 0.70 µF over the full range of the operating conditions. The full range of the
operating conditions in the application must be considered during device selection to ensure that the minimum capacitance specification
is met. X7R and X5R type capacitors are recommended for use with the LDOs, but Y5V and Z5U capacitors are not recommended for use
with the LDOs.
Table 2.
Parameter
Symbol
Conditions
Min
Typ
Max
Unit
MINIMUM INPUT AND OUTPUT CAPACITANCE
CMIN
TA = −40°C to +125°C
0.70
µF
CAPACITOR ESR
RESR
TA = −40°C to +125°C
0.001
1
Ω


Similar Part No. - ADP222ACPZ-1825-R7

ManufacturerPart #DatasheetDescription
logo
Analog Devices
ADP220 AD-ADP220 Datasheet
586Kb / 20P
   Dual, 200 mA, Low Noise, High PSRR Voltage Regulator
Rev. H
ADP220-2828-EVALZ AD-ADP220-2828-EVALZ Datasheet
586Kb / 20P
   Dual, 200 mA, Low Noise, High PSRR Voltage Regulator
Rev. H
ADP220ACBZ-1118R7 AD-ADP220ACBZ-1118R7 Datasheet
586Kb / 20P
   Dual, 200 mA, Low Noise, High PSRR Voltage Regulator
Rev. H
ADP220ACBZ-1212R7 AD-ADP220ACBZ-1212R7 Datasheet
586Kb / 20P
   Dual, 200 mA, Low Noise, High PSRR Voltage Regulator
Rev. H
ADP220ACBZ-1812R7 AD-ADP220ACBZ-1812R7 Datasheet
586Kb / 20P
   Dual, 200 mA, Low Noise, High PSRR Voltage Regulator
Rev. H
More results

Similar Description - ADP222ACPZ-1825-R7

ManufacturerPart #DatasheetDescription
logo
Texas Instruments
LP5910_017 TI1-LP5910_017 Datasheet
1Mb / 34P
[Old version datasheet]   300-mA Low-Noise, Low-IQ LDO
LP5910 TI1-LP5910_17 Datasheet
1Mb / 29P
[Old version datasheet]   300-mA Low-Noise, Low-IQ LDO
LP5910 TI1-LP5910_V01 Datasheet
1Mb / 35P
[Old version datasheet]   LP5910 300-mA Low-Noise, Low-IQ LDO
LP5910 TI1-LP5910_V02 Datasheet
1Mb / 35P
[Old version datasheet]   LP5910 300-mA Low-Noise, Low-IQ LDO
logo
NXP Semiconductors
LD6836 NXP-LD6836 Datasheet
589Kb / 28P
   Ultra low dropout regulators, low noise, 300 mA
Rev. 2-5 October 2012
logo
Texas Instruments
LP5910 TI-LP5910_V03 Datasheet
2Mb / 31P
[Old version datasheet]   LP5910 300-mA Low-Noise, Low-IQ LDO
logo
Microchip Technology
MIC5396 MICROCHIP-MIC5396 Datasheet
3Mb / 26P
   Low-Power Dual 300 mA LDO
Rev. C .April 2022
logo
ON Semiconductor
NCP2860 ONSEMI-NCP2860_06 Datasheet
117Kb / 9P
   300 mA Very Low Noise, Low Dropout Linear Regulator
April, 2006 ??Rev. 8
NCP2860DMADJR2G ONSEMI-NCP2860DMADJR2G Datasheet
210Kb / 11P
   300 mA Very Low Noise, Low Dropout Linear Regulator
July, 2010 ??Rev. 12
NCP2860 ONSEMI-NCP2860 Datasheet
119Kb / 12P
   300 mA Very Low Noise, Low Dropout Linear Regulator
October, 2002 - Rev. 6
More results


Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24


Datasheet Download

Go To PDF Page


Link URL




Privacy Policy
ALLDATASHEET.NET
Does ALLDATASHEET help your business so far?  [ DONATE ] 

About Alldatasheet   |   Advertisement   |   Contact us   |   Privacy Policy   |   Link Exchange   |   Manufacturer List
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com