Electronic Components Datasheet Search |
|
EZR-LEDK2W-434 Datasheet(PDF) 3 Page - Silicon Laboratories |
|
EZR-LEDK2W-434 Datasheet(HTML) 3 Page - Silicon Laboratories |
3 / 14 page Si4455-2Wa yLink-DEMO Rev. 0.1 3 2. Range Test Demo 2.1. Basics As it was stated above range test demo is used to provide measured results on the quality of the RF link. The demo uses two RFstick one of them as the ‘transmitter’ (TX) other as the ‘receiver’ (RX). Both RFsticks can be either transmitters or receiver. The transmitter sends packets to the receiver repeatedly with half second interval. The packet includes address of the transmitter and number of the sent packet. The packet number increments from packet to packet. The receiver receives the packet and checks its address. If their addresses match packet number is stored. The receiver then sends back an acknowledge packet (ACK) to the transmitter. ACK packet also includes the address and the packet number of the received packet. PER can be calculated with the following equation: The transmitter can calculate PER using the following data: PTX is the packet counter to be included in the packet PRX is the number of all the received acknowledge packets The receiver can calculate PER using the following data: PTX is the packet number included in the last received packet PRX is the number of all received data packets 2.2. RF and Demo Parameters This section provides information on the user parameters of the range test demo. All the parameters (excluding frequency band) can be changed in the demo through its menu system (see "2.4. Menu System of the Range Test Demo" on page 6). The following parameters are available: Frequency band (defined by the HW) Communication frequency (selected by the user) Node address (selected by the user) Modulation (selected by the user) Data rate (selected by the user) Demo settings are stored in the MCU’s flash memory and restored after power on reset. Default values are loaded if no settings were previously stored in the flash. It is also possible to define custom RF parameters for communication. Custom parameters can be stored with the Wireless Development Suit (WDS). For more information on creation and storage of custom parameters, refer to the WDS User’s guide for EZRadio Next Generation. PER P TX P RX – P TX --------------------------- 100 Where: PER is the packet error rate (%) P TX is the number of sent packets P RX is the number of received packets = |
Similar Part No. - EZR-LEDK2W-434 |
|
Similar Description - EZR-LEDK2W-434 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.NET |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |