E3X-NA

11

Amplifier Units with Connectors

● Mounting

Mounting Connectors

1. Insert the Master or Slave Connector into the Amplifier Unit until it

clicks into place.

2. Join Amplifier Units together as required after all the Master and

Slave Connectors have been inserted.

3. Attach the seals (provided as accessories) to the sides of Master

and Slave Connectors that are not connected to other Connectors.

Note: Attach the stickers to the sides with grooves.

Removing Connectors

1. Slide the slave Amplifier Unit for which the Connector is to be

removed away from the rest of the group.

2. After the Amplifier Unit has been separated, press down on the

lever on the Connector and remove it. (Do not attempt to remove

Connectors without separating them from other Amplifier Units

first.)

Mounting End Plate (PFP-M)

Depending on how it is mounted, an Amplifier Unit may move during

operation. In this case, use an End Plate.

Before mounting an End Plate, remove the clip from the master

Amplifier Unit using a nipper or similar tool.

The clip can also be removed using the following mechanism, which

is incorporated in the construction of the section underneath the clip.

1. Insert the clip to be removed into the slit underneath the clip on

another Amplifier Unit.

2. Remove the clip by rotating the Amplifier Unit.

Pull Strengths for Connectors (Including Cables)

E3X-CN11: 30 N max.

E3X-CN12: 12 N max.

Insert

Sticker

Sticker

Remove

Lever

Press down

Clip

Rotate