8-BIT SERIAL-INPUT,

LATCHED DRIVERS

115 Northeast Cutoff, Box 15036

Worcester, Massachusetts 01615-0036 (508) 853-5000

TIMING CONDITIONS

A.

Minimum Data Active Time Before Clock Pulse

(Data Set-Up Time) ....................................................................... 75 ns

B.

Minimum Data Active Time After Clock Pulse

(Data Hold Time) ........................................................................... 75 ns

C.

Minimum Data Pulse Width .............................................................. 150 ns

D.

Minimum Clock Pulse Width ............................................................ 150 ns

E.

Minimum Time Between Clock Activation and Strobe ....................... 30 ns

F.

Minimum Strobe Pulse Width ........................................................... 100 ns

G.

Typical Time Between Strobe Activation and

Output Transition .......................................................................... 1.0

TRUTH TABLE

Serial

Shift Register Contents

Serial

Latch Contents

Output Contents

Data

Clock

Data

Strobe

Output

Input

Output

Input

Enable

HH

LL

X

X

X

.............. X

X

L

X

X

X

.............. X

H

H

H

H

..............

H

L = Low Logic Level

H = High Logic Level

X = Irrelevant

P = Present State

R = Previous State

Dwg. No. A-12,627

Serial Data present at the input is

transferred to the shift register on the

logic “0” to logic “1” transition of the

CLOCK input pulse. On succeeding

CLOCK pulses, the registers shift data

information towards the SERIAL DATA

OUTPUT. The SERIAL DATA must

appear at the input prior to the rising edge

of the CLOCK input waveform.

Information present at any register is

transferred to its respective latch when the

STROBE is high (serial-to-parallel con-

version). The latches will continue to

accept new data as long as the STROBE

is held high. Applications where the

latches are bypassed (STROBE tied high)

will require that the ENABLE input be

high during serial data entry.

When the ENABLE input is high, all

of the output buffers are disabled (OFF)

without affecting the information stored

in the latches or shift register. With the

ENABLE input low, the outputs are

controlled by the state of the latches.

A

D

B

C

E

F

CLOCK

DATA IN

STROBE

OUTPUT

ENABLE

G