OPA336, 2336, 4336

2

SBOS068C

www.ti.com

PACKAGE

DRAWING

PACKAGE

PRODUCT

PACKAGE-LEAD

DESIGNATOR

MARKING

Single

OPA336N

SOT23-5

DBV

OPA336NA

SOT23-5

DBV

OPA336NJ

SOT23-5

DBV

J36

OPA336U

SO-8 Surface-Mount

D

OPA336U

OPA336UA

SO-8 Surface-Mount

D

OPA336UA

OPA336UJ

SO-8 Surface-Mount

D

OPA336UJ

Dual

OPA2336E

MSOP-8 Surface-Mount

DGK

OPA2336EA

MSOP-8 Surface-Mount

DGK

OPA2336P

DIP-8

P

OPA2336P

OPA2336PA

DIP-8

P

OPA2336PA

OPA2336U

SO-8 Surface-Mount

D

OPA2336U

OPA2336UA

SO-8 Surface-Mount

D

OPA2336UA

Quad

OPA4336EA

SSOP-16 Surface-Mount

DBQ

OPA4336EA

NOTES: (1) For the most current package and ordering information, see the package option addendum at the end of this data sheet. (2) Grade will be marked on

the Reel.

ELECTROSTATIC

DISCHARGE SENSITIVITY

This integrated circuit can be damaged by ESD. Texas

Instruments recommends that all integrated circuits be handled

with appropriate precautions. Failure to observe proper han-

dling and installation procedures can cause damage.

ESD damage can range from subtle performance degrada-

tion to complete device failure. Precision integrated circuits

may be more susceptible to damage because very small

parametric changes could cause the device not to meet its

published specifications.

Supply Voltage ................................................................................... 7.5V

Operating Temperature .................................................. –55

°C to +125°C

Storage Temperature ..................................................... –55

°C to +125°C

Junction Temperature ...................................................................... 150

°C

Lead Temperature (soldering, 10s) ................................................. 300

°C

ESD Rating:

NOTES: (1) Stresses above these ratings may cause permanent damage.

Exposure to absolute maximum conditions for extended periods may

degrade device reliability. These are stress ratings only. Functional opera-

tion of the device at these conditions, or beyond the specified operating

conditions, is not implied. (2) Input terminals are diode-clamped to the power

supply rails. Input signals that can swing more than 0.3V beyond the supply

rails should be current-limited to 10mA or less. (3) Short-circuit to ground,

one amplifier per package. (4) OPA336 NJ and UJ have been tested to CDM

of 1000V. All other previous package versions have been tested using HBM

and MM. Results are shown.