Category

Classic

Dual Mode

Low

Energy

Module Image

Series

PAN1315A/1325A

PAN1311/1321

PAN1321i

PAN1455/1555

PAN1316/1326

PAN1317/1327

PAN1720

Function

(no/with antenna)

Ver 2.1 EDR - HCI

(no/with antenna)

Ver 2.0 EDR - SPP

(with antenna)

Ver 2.0 EDR - SPP

(no/with antenna)

Ver 3.0 EDR -

SPP, HID, HDP

(no/with antenna)

Ver 4.0 EDR - HCI

(no/with antenna)

Ver 2.1 EDR - HCI

(with antenna)

Ver 4.0 EDR BLE

Size [mm]

9.0 x 6.5 x 1.7

9.0 x 9.5 x 1.7

11.6 x 8.7 x 1.8

15.6 x 8.7 x 2.8

15.6 x 8.7 x 2.8

18.8 x 13.5 x 2.5

9.0 x 6.5 x 1.7

9.0 x 9.5 x 1.7

9.0 x 6.5 x 1.7

9.0 x 9.5 x 1.7

15.6 x 8.7 x 1.8

IC

CC2560A

PMB8753/2

PMB8753/2

BC6 / STM32F103

CC2564

CC2567

CC2540 / (41)

Rx Sensitivity [dBm]

-93 @ BER 10-3

-86 @ BER 10-3

-86 @ BER 10-3

-86 @ BER 10-3

-93 @ BER 10-3

-93 @ BER 10-3

-94 @ BER 1%

Tx Power (max.)

+10.5 dBm

+4 dBm

+4 dBm

+4 dBm

+10.5 dBm

+10.5 dBm

+3 dBm

Operating Temp.

-20 to +70 °C

-40 to +85 °C

-40 to +85 °C

-40 to +85 °C

-20 to +70 °C

-20 to +70 °C

-40 to +85 °C

Power Supply

1.8 to 4.8 V

2.7 to 3.6 V

2.7 to 3.6 V

2.7 to 3.6 V

1.8 to 4.8 V

1.8 to 4.8 V

2.0 to 3.6 V

Current Consum.

135 µA (sleep)

40 mA (Tx,EDR)

80 µA (sleep)

40 mA (Tx,EDR)

80 µA (sleep)

40 mA (Tx,EDR)

<100 µA (sleep)

47 mA (ACL; DH1)

135 µA (sleep)

40 mA (Tx,EDR)

135 µA (sleep)

40 mA (Tx,EDR)

>1µA (sleep)

Tx23mA @ -6dBm

Frequency Range

2.4 GHz

2.4 GHz

2.4 GHz

2.4 GHz

2.4 GHz

2.4 GHz

2.4 GHz

Number of GPIOs

2

>15

>15

18

2

2

19

Interfaces

GPIO, PCM, UART

GPIO, UART,

JTAG

GPIO, UART,

JTAG

GPIO, UART, I²C,

SPI, ADC

GPIO, PCM, UART

GPIO, PCM, UART

GPIO, UART

(USB)

Data Rate

(max. air)

3 MBit/s

3 MBit/s

190 kBit/s

3 MBit/s

ca. 500 kBit/s

3 MBit/s

3 MBit/s

1 MBit/s

Dev Kit

EVAL_PAN1323

EVAL_PAN1321i

EVAL_PAN1555

EVAL_PAN1323

EVAL_PAN1720

Dev Module

EVAL_PAN1323ETU

EVAL_PAN1321iETU

EVAL_PAN1323ETU

Bluetooth Low Energy

Bluetooth Dual Mode

Bluetooth Classic, formerly known as Bluetooth and Bluetooth EDR, is a networking standard designed to meet IEEE 802.15.1 and

administered by the Bluetooth Special Interest Group (BT SIG). Conceived as a 2.4GHz wireless standard to replace wired headsets

in 1999, Bluetooth has grown in both scope and capability. By far it is the most prolific wireless standard today adding over 1,000,000

nodes to the network every day, in cell phones, PC’s, consumer and medical electronics applications and many more. Bluetooth Classic

is best suited to high data rate – up to 3Mbits/sec – applications where the network size is under eight nodes. Larger networks can be

formed with Scatternets. Connections are robust, even in noisy environments, by using 80 channels, each 1MHz wide, adaptive

frequency hopping, and multiple modulation schemes. Range can be adjusted using hardware and software from under a meter to over

two hundred meters. Panasonic offers four Series of Bluetooth devices with over 20 parts numbers to address nearly every application.

Bluetooth Low Energy is designed to reduce power consumption. It can be put into a sleep mode and only activates for event

activities such as sending data to a gateway, PC or mobile phone. Furthermore, the maximum power consumption is less than 15 mA

and the average power consumption is about 1 uA. The foundations of low energy consumption are short messages and establishing

very fast connections (few ms). Using these techniques, energy consumption is reduced to a tenth of a Classic Bluetooth unit. Thus, a

small coin cell – such as a CR2032 – is capable of powering a device for up to 10 years of operation.

ANT™ is a wireless sensor network protocol operating in the 2.4 GHz spectrum. Designed for ultra-low power, ease of use, efficiency

and scalability, ANT supports peer-to-peer, star, tree and fixed mesh topologies. It provides reliable data communications, flexible and

adaptive network operation and cross-talk immunity. The ANT protocol stack is compact, requiring minimal microcontroller resources

to reduce system costs, lighten the computational burden and improve efficiency. Low-level security is implemented to allow

user-defined network security.

design; all while reducing costs associated with incorporating two wireless technologies. These modules have been designed to be

100% pin compatible with other members of the PAN13xx family. This unique design feature enables designers to seamlessly

transition between Bluetooth Classic, Low Energy and ANT™ enabled modules, addressing larger markets and providing migration

paths to circumvent obsolescence.

Apple, iPod, iPhone and iPad are registered trademarks of Apple Inc.

The Bluetooth® word mark and logos are registered tandemarks owned by Bluetooth SIG, Inc and any use of such marks by Panasonic Corporation of North America is under license. Other trademarks and

trade names are those of their respective owners.

+ ANT™

+ Low

Energy

Apple®

Device

Compatible!

Apple®

Device

Compatible!