1-355

Notes:

1. Measured at a point 1.6 mm below seating plane.

2. Current into/out of any single lead.

3. Surge input current duration is 3 ms at 120 Hz pulse repetition rate. Transient input current duration is 10

µs at 120 Hz pulse

4. Derate linearly above 70

°C free-air temperature at a rate of 4.1 mW/°C. Maximum input power dissipation of 230 mW allows an input

IC junction temperature of 125

°C at an ambient temperature of T

of

θ

5. Derate linearly above 70

°C free-air temperature at a rate of 5.4 mW/°C.

6. Derate linearly above 70

°C free-air temperature at a rate of 3.9 mW/°C. Maximum output power dissipation of 210 mW allows an

output IC junction temperature of 125

°C at an ambient temperature of T

ambient of

θ

7. Derate linearly above 70

°C free-air temperature at a rate of 0.6 mA/°C.

a 5 V square wave input signal.

level on the leading edge of the output pulse (see Figure 10).

level on the trailing edge of the output pulse (see Figure 10).

15. AC voltage is instantaneous voltage.

16. Device considered a two terminal device: Pins 1, 2, 3, 4 connected together, and Pins 5, 6, 7, 8 connected together.

17. In accordance with UL 1577, each optocoupler is proof tested by applying an insulation test voltage

≥ 3000 V rms for 1 second

Figure 1. Typical Input Characteristics, I

IN

vs. V

IN

(AC Voltage is Instantaneous Value).