 |
Electronic Components Datasheet Search |
|
|
Electronic Components Datasheet Search |
|
SP207EH Datasheet(PDF) 7 Page - Sipex Corporation |
|
||||||||||||||||||||||||||||||
SP207EH Datasheet(HTML) 7 Page - Sipex Corporation |
|
|
7 / 16 page  7 SP207EHDS/08 SP207EH Series High Performance Transceivers © Copyright 2000 Sipex Corporation Figure 4. Charge Pump — Phase 3 VCC = +5V –5V +5V –5V VSS Storage Capacitor VDD Storage Capacitor C1 C2 C3 C4 + + ++ – – – – Receivers The high performance receivers of the SP207EH Series can accept input signals at a typical data rate of 500Kbps. The receivers convert RS-232 input signals to inverted TTL signals. The receivers convert RS-232 input signals to inverted TTL signals. Since the input is usually from a transmission line where long cable lengths and system interference can degrade the signal, the inputs have a typical hysteresis margin of 500mV. This ensures that the receiver is virtually immune to noisy transmission lines. Should an input be left unconnected, a 5k Ω pulldown resistor to ground will commit the output of the receiver to a high state. SHUTDOWN MODE The SP211EH, and SP213EH all feature a control input which will disable the device and reduce the power supply current to less than 10 µA, making the parts ideal for battery– powered systems. In the “shutdown” mode the receivers and transmitters will both be tri–stated. The V+ output of the charge pump will discharge to V CC, and the V – output will discharge to ground. Products with the Wake-Up function can enable or disable the receivers during shutdown. Figure 5. Charge Pump — Phase 4 VCC = +5V +10V VSS Storage Capacitor VDD Storage Capacitor C1 C2 C3 C4 + + ++ – – – – For complete shutdown to occur and the 10 µA power drain to be realized, the following conditions must be met: SP211EH: • +5V must be applied to the SD pin • ENABLE must be either 0V, +5.0V or not connected • the transmitter inputs must be either +5.0V or not connected • V CC must be +5V • Receiver inputs must be >0V and <+5V SP213EH: • 0V must be applied to the SD pin • ENABLE must be either 0V, +5.0V or not connected • the transmitter inputs must be either +5.0V or not connected • V CC must be +5V • Receiver inputs must be >0V and <+5V |
Similar Part No. - SP207EH |
|
Similar Description - SP207EH |
|
|
|
Link URL |
| Privacy Policy |
| ALLDATASHEET.NET |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
