Electronic Components Datasheet Search |
|
SP6201ER-1-8 Datasheet(PDF) 3 Page - Sipex Corporation |
|
SP6201ER-1-8 Datasheet(HTML) 3 Page - Sipex Corporation |
3 / 17 page 3 Date:5/25/04 SP6200/6201 100/200mA CMOS LDO Regulator © Copyright 2004 Sipex Corporation Note 1. Exceeding the absolute maximum rating may damage the device. Note 2. The device is not guaranteed to function outside its operating rating. Note 3. The maximum allowable power dissipation at any T A (ambient temperature) is PD (MAX) = (TJ (MAX) – TA) / θϑA . Exceeding the maximum allowable power dissipation will result in excessive die temperature, and the regulator will go into thermal shutdown. The θ JA of the SP6200/6201 (all versions) is 90°C/W for the SOT-23-5 and 59°C/W for the DFN package on a standard 4 layer board (see “Thermal Considerations” section for further details). Note 4. Output voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature range. Note 5. Load Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are tested for load regulation in the load range; from 0.1mA to 100mA, SP6200; from 0.1mA to 200mA, SP6201. Changes in output voltage due to heating effects are covered by the thermal regulation specification. Not applicable to output voltages less than 2.5V. Note 6. Dropout Voltage is defined as the input to output differential at which the output voltage drops 2% below its nominal value measured at 1V differential. Not applicable to output voltages less than 2.7V. Note 7. Ground pin current is the regulator quiescent current. The total current drawn from the supply is the sum of the load current plus the ground pin current. Note 8. Thermal regulation is defined as the change in output voltage at a time ”t” after a change in power dissipation is applied, excluding load or line regulation effects. Specifications are for a 100mA load pulse at V IN = 6V for t = 10ms. ELECTRICAL CHARACTERISTICS: Continued V IN = VOUT +1V, VO = 5V for ADJ, IL = 100µA, CIN = 1.0µF, COUT = 1.0µF, TJ = 25 °C , unless otherwise specified. The ♦ denotes the specifications which apply over the full operating temperature range, unless otherwise specified. PARAMETER MIN TYP MAX UNITS ♦ ♦ ♦ ♦ ♦ CONDITIONS Thermal Regulation, 0.05 %/W Note 8, (∆VO/∆PD) Output Noise, (e no)IL = 50mA, CL = 1µF 150 µVrms 0.1µF from VOUT to Adj. 10Hz to 100kHz ENABLE INPUT Enable Input Logic-Low Voltage, 0.4 V ♦ Regulator Shutdown (VIL) Enable Input Logic-High Voltage, 1.6 V ♦ Regulator Enabled (VIH) Enable Input Current, (IIL), (IIH) 0.01 1 µA ♦ VIL < 0.4V 0.01 1 µA ♦ VIH > 2.0V Reset Not Output -2 -4 -6 % Threshold |
Similar Part No. - SP6201ER-1-8 |
|
Similar Description - SP6201ER-1-8 |
|
|
Link URL |
Privacy Policy |
ALLDATASHEET.NET |
Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |