LM2651

www.ti.com

SNVS032E – FEBRUARY 2000 – REVISED JANUARY 2016

7.3 Feature Description

When the load current is higher than the sleep mode threshold, the part is always operating in PWM mode. At

the beginning of each switching cycle, the high-side switch is turned on, the current from the high-side switch is

sensed and compared with the output of the error amplifier (COMP pin). When the sensed current reaches the

COMP pin voltage level, the high-side switch is turned off; after 40 ns (deadtime), the low-side switch is turned

on. At the end of the switching cycle, the low-side switch is turned off; and the same cycle repeats.

When the load current decreases below the sleep mode threshold, the output voltage rises slightly, this rise is

sensed by the hysteretic mode comparator which makes the part go into the hysteretic mode with both the high

and low side switches off. The output voltage starts to drop until it hits the low threshold of the hysteretic

comparator, and the part immediately goes back to the PWM operation. The output voltage keeps increasing

until it reaches the top hysteretic threshold, then both the high- and low-side switches turn off again, and the

cycle repeats.

7.4 Device Functional Modes

The cycle-by-cycle current limit circuitry turns off the high-side MOSFET whenever the current in MOSFET

reaches 2 A. A shutdown pin is available to disable the LM2651 and reduce the supply current to 7 µA.

Copyright © 2000–2016, Texas Instruments Incorporated

Submit Documentation Feedback

11

Product Folder Links: LM2651