Typical Application Information

General application guidelines and hints for differential driv-

ers receivers may be found in the following application

notes:

AN-214, AN-457, AN-805, AN-847, AN-903, AN-912, AN-916

Power Decoupling Recommendations: Bypass caps must be

used on power pins. High frequency ceramic (surface mount

is recommended) 0.1 µF in paraIIel with 0.01 µF at the power

supply pin. A 10 µF or greater solid tantalum or electrolytic

should be connected at the power entry point on the printed

circuit board.

DS012644-4

FIGURE 3. Receiver TRI-STATE Test Circuit

DS012644-5

FIGURE 4. Receiver TRI-STATE Output Enable and Disable Waveforms (Notes 9, 10)

www.national.com

4