1.2

1.1

1.0

REV

2015-08-06

2014-06-11

2014-01-22

DATE

KaS

SSt

SSt

BY

SBa

SSt

SBa

CHECKED

Würth Elektronik eiSos GmbH & Co. KG

EMC & Inductive Solutions

Max-Eyth-Str. 1

74638 Waldenburg

Germany

Tel. +49 (0) 79 42 945 - 0

www.we-online.com

eiSos@we-online.com

DESCRIPTION

WE-UCF SMD Common Mode Line Filter

Order.- No.

744290152

SIZE

A4

A Dimensions: [mm]

B Recommended land pattern: [mm]

C Schematic:

D Electrical Properties:

Properties

Inductance

Rated current

DC Resistance

Leakage inductance

Insulation test voltage

Rated voltage

Test conditions

10 kHz/ 50 mV

∆T = 40 K

@ 20°C

1 MHz/ 1 mA

50 Hz

L

IR

RDC

LS

UT

UR

Value

2x 1.5

1.5

2x 0.12

13000

500

80

Unit

mH

A

Ω

nH

V (AC)

V

Tol.

±30%

max.

max.

typ.

max.

E General information:

It is recommended that the temperature of the part does not exceed 125°C

under worst case operating conditions.

•Ambient temperature: -40°C to +85°C (refering to IR)

•Operating temperature: -40°C to +125°C

•Storage temperature (on tape & reel): -20°C to +40°C; 75% RH max.

•Test conditions of Electrical Properties: 20°C, 33% RH

if not specified differently

This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement specifically governing such use.

Moreover Würth Elektronik eiSos GmbH & Co KG products are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc.. Würth Elektronik eiSos GmbH & Co KG must be informed about the intent of such usage before

the design-in stage. In addition, sufficient reliability evaluation checks for safety must be performed on every electronic component which is used in electrical circuits that require high safety and reliability functions or performance.