408-10050

Rev D

5 of 8

5.1. Crimp Inspection (Figure 4)

NOTE

The accompanying procedure is included as an aid to the local operator ONLY. It is not intended to

serve as a quality control procedure for qualifying finished crimps on SOLISTRAND terminals or

splices.

Inspect crimped terminals or splices by checking the features described in Figure 4. USE ONLY terminals or

splices that meet the conditions shown in the ACCEPT column. Terminals and splices displaying the features

shown in the REJECT column can be avoided by careful use of these instructions and by performing the

maintenance and inspection procedures described in paragraphs 5.2. and 5.3.

Figure 4